Cutter is new and was carefully removed from the box only to be tested and found to be in good working condition. Cutter comes with everything you will need to get started including a small amount of sign vinyl to dial it in and to get you up to speed with using it. This is an entry level unit but it will do a good job when using clean artwork and the proper procedures are used by the operator. This unit is a little loud and sounds like the Old School video games but that is normal because of the stepper motors it uses. The very quiet units on the market use Servo Motors which are much more expensive. WinPC Sign Basic is a good starting point for designing your artwork and the supplied Training DVD is helpful with learning how to use the software. The software runs best on XP, Windows 7, and Vista. This software IS NOT Mac Compatible!! You will need a USB port for the dongle key to remain in place to run the software. You have the option of running the cutter with a USB or Serial cable and both of these cables are included. Please be sure you have all the available ports. Included is an extra cutting strip and one each 45 and 60 degree blade. The software in the photo is an open one only to show what you will get. Yours will be new and unopened so you can register it with the manufacture. Very important thing to consider: I do not do tech support but I will include a Start Up Manual with instructions on how to set up the cutter as well as an assembly diagram for the stand. If all the instructions are followed carefully you should not have an issue with the cutter working properly. There is a learning curve to using a vinyl cutter as well as the software and understanding what works and what won’t. If you are just getting into this type of work please be aware you will need some patience but once you get the hang of it you will become more creative and get good results. I recommend doing some research on how to use vinyl cutters as well as get familiar with what to expect with regards to using the software as well as looking into how to apply vinyl. If you misunderstand the principals and ignore the basics you are going to have issues and get frustrated. These are suggestions to consider before you invest in this cutter so you will not be unhappy with it later on. If UPS tears it up it will be your responsibility to file a claim with them. The box dimensions are 12″ H x 12″ W x 40 L and weighs in at 30lbs. Note: Due to some buyers not leaving Feedback in the past I will leave it for you after I receive it. The item “New Red Sail 24 Vinyl Cutter / Plotter With Stand & Software READ ALL NOTES” is in sale since Monday, March 05, 2018. This item is in the category “Business & Industrial\Printing & Graphic Arts\Plotters, Wide Format Printing\Cutters- Wide Format”. The seller is “rabbit1212″ and is located in Mount Holly, North Carolina. This item can be shipped to United States.
- Brand: Red Sail
- Model: RS720C
- Country/Region of Manufacture: China
- Bundle Listing: Yes